How do I set up a default label printer?

How do I set up a default label printer?

You need to go to sysadm tool and set the earmould label and patient label if required, to send to label printer in the printer extension as below

Then go to workstation settings and select the default printer configuration as shown below

This will need to be repeated on each workstation.  

You can use workstation management to clone the settings to all PCs.

    • Related Articles

    • How do I set up Auditbase for Waiting List Prioritisation?

      +44 (0) 333 444 4212 Setting up Auditbase for Waiting List Prioritisation. The clinical validation of diagnostic waiting lists project[1] will produce a clinically validated waiting list that allows diagnostic ...
    • How do I set Auditbase to support 5 minute appointments?

      System Administration Booking and Timetable: There have been changes made to the Booking and Timetable portion of AuditBase. This has improved the reliability of the system when there are multiple users on the system. The previous restriction of 250 ...
    • Stock Module

      This course will teach you all you need to know about the Stock Module, including: Setup Manufacturer Set Up Article and Article Group Set Up Creating and Modifying Services Adding Suppliers Using the Stock Module (Patient Related) Searching for a ...
    • How do I change the number of resources shown in the Booking Module?

      Auditbase will default to 5 visible resources in the Booking Module until a change is made in the Administration settings. To change this setting Auditbase Administration should be opened and then User and Workstation options -> Workstation settings ...
    • How do I install 64 Bit drivers?

      64 Bit drivers 64-bit drivers (ODBC and OLE DB) let 64-bit applications (like MS Office 64-bit) access SqlBase databases. Installation is intended for use in 64-bit environment where AuditBase is already installed and configured. To install drivers - ...