How to verify transducers are correctly recognized by the Fitting Unit

How to verify transducers are correctly recognized by the Fitting Unit

When setting up a new transducer, ensure it is recognized by the Fitting Unit. To do so, follow the instructions:

  1. Connect the Fitting Unit to the PC using the USB cable.
  2. Start Measure/Primus/Unity software.
  3. Wait until the Fitting Unit is initialized and connected. The current connection status is displayed on the right side of the status bar at the bottom of the screen.
  4. Disconnect the old transducer.
  5. Connect the new transducer to the Fitting Unit.
  6. In Measure/Primus/Unity software, go to Help > License Information > Connected Devices.
  7. Review the name and serial number of the new transducer.
    If the data corresponds to the new transducer, you can use the system normally.
    If the data corresponds to the old transducer, proceed with the next steps.
  8. In Measure/Primus/Unity software, go to Tools > Refresh Transducer Data.
  9. Select the needed transducer and click Refresh Transducer Data.
  10. Wait until this process is finished and close this window.
  11. You can close the window and start using the system normally.

IMPORTANT! The above needs to be completed to ensure the transducers are working properly.

    • Related Articles

    • Information About SWAP Service

      What is the SWAP Service? The SWAP Service ensures your transducers remain accurate and calibrated without downtime. If your transducer is out of calibration, you can easily replace it with a newly calibrated one. How It Works Request a Replacement – ...

    • Auditdata SWAP service

      Instructions for the proper transducer exchange in place Introduction This document explains how to ensure that the new transducer was recognized by Measure fitting unit. Instructions Connect the Fitting Unit to the PC using the USB cable Start ...

    • Technical Instructions for Use - Audiometer and Fitting Unit

      This document aims to provide instructions on setting up Fitting and HIT Units and installing and configuring the Measure software. It also includes essential information on safety measures, maintenance, and calibration. The Fitting Unit is a general ...

    • Video - How to Connect the Measure Audiometer & Fitting Unit to the Loudspeaker

      This video shows how to connect the Measure audiometer & fitting unit to the loudspeaker.

    • User Manual for Measure - Audiometer and Fitting Unit

      The Measure Fitting System contains all the functions required to perform audiometry, real ear measurements, speech mapping, and testing of hearing instruments when required. The system operates within the NOAH framework and you can use it ...