Playing High Frequency (HF) sounds in Primus software

Playing High Frequency (HF) sounds in Primus software

To play HF sounds in Primus software transducer itself should support HF range higher than 8KHz.
List of HF transducers is described on the page 61 of the Instruction for Use (available in Help tab in Primus).



HF transducer should be connected to Air Conductor port 3 (yellow HF port) of the Primus board.
If transducer supports HF range and is connected to HF port, it should emit HF sound, up to 16KHz.
If same transducer is connected to Air Conductor port 1 or 2, it will emit the ordinary sound, up to 8KHz.



HF setting should be enabled in Primus software on the measurement page, thus HF range will be available on graph.



    • Related Articles

    • File - Downloading Primus software

      Mark your calendar for our November release! We're thrilled to announce some transformative changes to our beloved Primus Software! Driven by our commitment to continuously enhance your user experience, we've made significant updates that we're ...

    • Hardware error displayed in Primus

      1. Run hardware diagnostic test Enable Hardware Diagnostic Test in Tools > Settings > General > Common   Start the test under Tools > Hardware Diagnostic Test Select the device (Measurement or Hearing Instrument), all needed parameters, and ...

    • Technical Instructions for Use & User Manual - Primus

      This document aims to provide instructions on setting up Primus and installing and configuring the Primus software. It also includes essential information on safety measures, maintenance, and calibration. The Fitting Unit is a general term combining ...

    • How can I access support tools in Primus?

      Using Help in Primus you can get access to How To Videos - Providing step by step guides to install, use and customise Primus settings. Training videos can also be found here User Manual and Instructions for Use documents - these can be accessed ...

    • Primus does not recognize transducer - "Sound Booth Cable Connection" message

      IMPORTANT Please note that some transducers will only work with a Fitting unit that run with firmware version equal: 3.2.0.0.0247 or higher and Primus version 4.0 Check firmware procedure: 1. Please start the Audiometer software with the Fitting Unit ...